Fenders are usually installed on the rear and front of the cars, respectively, to prevent mud splashing when it rains. What’s more, they can also protect our car bodies from being damaged when run over by other vehicles or falling down onto the ground. So, why not install fenders? To answer this question, you’d better read the following content carefully and make your own decision afterwards.
Things you need to know about installing fenders on your car
Fender installation is simple. All you need are a few car fender parts and some basic hand tools. Check out the following infographic for a step-by-step installation guide:
- Remove the front wheel from your car
- Pry off the plastic part near the bottom of your wheel well
- Measure, cut and install two PVC pipes that measure approximately
4 feet long into the wheel wells.
Things worth knowing before buying fenders
Fenders are usually sold with a set of bolts and either studs or screws, which can be bought at any hardware store. Generally, metal fenders will take more time to install than plastic ones. Here are some things worth knowing before you buy fenders Fenders are usually sold with a set of bolts and either studs or screws, which can be bought at any hardware store.
Generally, metal fenders will take more time to install than plastic ones. Used car fenders can be affordable and perfect for you if your pocket does not allow you to replace them with new ones. So used car fender prices can be good for your pocket. It is not necessary to buy fenders if your car comes from the factory without them.
Why we should pay attention to the installation process
Fender installation is easy and only takes about one hour. You can install it with a friend, following the fender installation instructions provided by the manufacturer. However, if you want to do it by yourself, then you should read those instructions carefully before starting so that you can avoid making mistakes. Remember that the first step is to remove the old fender (if there was any) and place it in a safe place away from where you will be working. The next step is to clean your vehicle thoroughly in order to get rid of any dirt or grime that may have accumulated around the area where the new fender will be installed. Now it's time for you to open up your new fender package and start attaching all of its parts together as per instructed in its manual. As you're doing this, make sure to go slowly and use care not to damage anything while ensuring everything fits properly. Once everything is attached correctly, go ahead and apply some silicone sealant around each corner. Finally, wait until the sealant dries completely before proceeding.
The process has been completed! If you want to learn more about how an auto mechanic does their job or just happen to love cars in general, please feel free to explore our website for more posts related to this topic!
What are some common problems during the installation process?
Fender installation is not difficult, but there are a few common problems that people come across.
- Do not forget to get the fender installation instructions before you start. This can help you avoid wasting time and money as well as make the installation process more efficient and less frustrating.
- When installing a fender, it may not be possible to use the same bolt holes that were originally used for the old fender because the new ones will be too large or too small in diameter.
How much does it cost to buy and sell used fenders?
The cost of car fender replacement varies depending on the make and model of the car. For example, for a Toyota Corolla, it is typically between $600 and $1,000 for an OEM (original equipment manufacturer) part. For a Chevy Camaro SS, it is typically between $900 and $1,200. Replacing a fender can cost more than the car itself!
The cost of car fender replacement varies depending on a number of factors, including whether it is an OEM or aftermarket part. For example, for an OEM Toyota Corolla fender that costs about $600 new, you can get one second-hand for approximately $250. Aftermarket parts are also available from sources like Auto Parts Warehouse and AutoAnything. These generally start at around $75 used, but they usually need paint in order to be restored.